Clif project property "network address" cannot be changed
Whenever we change the network address property (using either the CLIF wizard or the project properties: Project properties / Network Properties / Choose network address), the network address cannot be properly changed, it always reverts to "localhost", even after a restart of the application.
Observed in a context where the CLIF Console is run as a plugin in a standard galileo installation, compiled from SVN revision 2329.
Test1:
- For any existing clif project in the workspace, go to Project properties / Network Properties.
- The "Choose network address" properly displays all the possible interface and IP address: localhost and 192.168.x.x eth0
- Select "192.168.x.x eth0", then press OK
- Optionnaly restart the application, as mentionned by the note in the same form
- Go back to Project properties / Network Properties -> "Choose network address" erroneously displays localhost instead of "192.168.x.x eth0"
Test2:
- Create a new CLIF project
- give a name, then Next, Next
- The "Choose network address" properly displays all the possible interface and IP address: localhost and 192.168.x.x eth0
- Select "192.168.x.x eth0", then press OK
- click "Finish"
- Go back to Project properties / Network Properties -> "Choose network address" erroneously displays localhost instead of "192.168.x.x eth0"
Expected behaviour: keep the selected address and interface, even if it does not exist on the current computer (and display an error message in the eclipse Problems or Error Log views).